Page
11
of
16
APPLIANCE INSTALLATION (cont.)
Leveling
Ensure the floor where the unit is to be located is level, or shim the unit to level.
Stabilizing
All models are supplied with casters for your convenience. It is very important, however, that the cabinet be installed in a stable
condition with the front wheels locked while in use. Should it become necessary to lay the unit on its side or back for any reason,
allow at least 24 hours before start-up to allow compressor oil to flow back into place. Failure to meet this requirement can cause
compressor failure and unit damage.
NOTICE:
Unit repairs will not be subject to standard unit warranties if due to improper installation procedures.
Electrical Connection
Refer to the amperage data on the Technical Information table, the serial tag, your local code or the National Electrical Code to be
sure that unit is connected to the proper power source.
DANGER
The unit must be turned OFF and disconnected from the power source whenever performing service,
maintenance functions or cleaning the refrigerated area. Failure to comply may result in Death or
Severe Personnel Injury.
OPERATION
Setting the Temperature Control
To control the internal temperature, adjust the control dials according to the intended use requirements for proper/safe
product storage.
1.
The first time you turn the unit on, set the temperature control to “7”. The range of the temperature control is from position
“1” [the warmest] to “7” [the coldest] in the freezer section.
2.
After 24 to 48 hours, adjust the temperature control to the setting that best suits your needs. The setting of “4” should
be correct for most home or office use needs or applications.
CAUTION
If the unit is unplugged, has lost power, or is turned off, you must wait at least 8 minutes before restarting the unit. If
you attempt to restart before this time delay, the appliance may not start properly.
NOTE:
•
Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off the power to the appliance.
•
If the unit is unplugged, loses power, or is turned off; you must wait at least 8 minutes before restarting the unit. If you
attempt to restart before this time delay, the appliance may not start properly.
•
Large amounts of food will lower the cooling efficiency of the appliance and may require a colder thermostat setting.
•
If you choose to change the thermostat setting, adjust thermostat control by one numerical increment at a time.
•
Allow several hours for temperature to stabilize between adjustments.
