Page
10
of
16
APPLIANCE INSTALLATION (cont.)
•
Avoid locating the unit in damp, very humid or moist areas.
•
Before connecting the unit to the power source, let it stand upright for approximately 4 hours. This will reduce the possibility of
a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water or mild detergent aqueous solution using a soft cloth that won’t scratch the
surface of this appliance.
Remove Packaging Materials
IMPORTANT:
Do not remove any permanent instruction labels or the data label on your appliance.
•
Remove tape and glue from your appliance before using.
•
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and
dry with a soft cloth.
•
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products
can damage the surface of your appliance.
NOTICE:
LOSS OR SPOILAGE OF PRODUCTS IN YOUR APPLIANCE IS NOT COVERED BY WARRANTY. IN ADDITION TO
FOLLOWING RECOMMENDED INSTALLATION PROCEDURES. PLEASE RUN THE APPLIANCE 24 HOURS PRIOR TO
USAGE.
Location Requirements
•
Appliances represented in this manual are intended for indoor use only.
•
Be sure the location chosen has a floor strong enough to support the total weight of the appliance and contents as a fully loaded
unit can weigh as much as 1500 pounds (680kg).
•
Reinforce the floor as necessary to provide for maximum loading.
•
For the most efficient refrigeration, be sure to provide good air circulation around appliance.
Installation Clearance
Be sure that the unit has access to ample air. Avoid hot corners and locations near stoves and ovens.
Allow 5 inches of space between the back and sides of the unit, which allows the proper air circulation to cool the compressor and
condenser.
TOP VIEW
Minimum
to wall: 5“
Minimum
to wall: 5“
Rear of Freezer
