23
FCC Compliance Information
Part 15 Compliance Statement
This device complies with Part 15 of the FCC
Rules. Operation is subjected to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with limits for a Class B digital device,
pursuant to Part 15 of the FCC rules and ETSI
(EN) 300328. These limits are designed to
provide reasonable protection against harmful
interference in residential installations. This
equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause interference to radio or
television equipment reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Move the equipment away from the receiver.
Plug the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/
television technician for additional suggestions.
►
►
►
►
CAUTION! Any changes or modifications to
this equipment not expressly approved by the
party responsible for compliance could void
your authority to operate the equipment.
RF Exposure Information
The antenna used for this transmitter must be
installed to provide a separation distance of at
least 20 cm (7.9”) from all persons and must not be
collocated or operating in conjunction with any
other antenna or transmitter.
IC Compliance Information
Radio Equipment Notice
The term “IC:” before the radio certification number
only signifies that Industry Canada technical
specifications were met. Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device. “Privacy of
communications may not be ensured when using
this device”.
CE Compliance Information
Products with CE Marking comply with EMC
Directive (2004/108/EC); Low Voltage Directive
(73/23/EEC); R&TTE(1999/5/EC) issued by the
Commission of the European Community.
Compliance with these directives implies conformity
to the following European Norms:
EMC: EN 301 489
LVD: EN 60950
Radio: EN 300 328
►
►
►
