unicraft 6172100, Руководство по эксплуатации

Страница: 8 / 16

8 PK 1 | Version 1.03
Assembly
7 Assembly
Equipment that is not used in a fixed location must be in-
stalled in such a way that it is horizontal and that no
crushing or shearing points can occur between the ma-
chine and parts of the environment. Furthermore, it must
be ensured that intended activities can be carried out
without hindrance.
Mount the gantry crane by using the exploded view
(Fig. 6).
Step 1: Attach one plate (20) to each side of the track
(19) with the screws (1), washers (2), spring
washers (3) and nuts (4). Likewise for the other
end of the track.
Step 2: Attach the two vertical brackets (21) to the track
(19) with eight sets of screws, washers, spring
washers and nuts (1, 2, 3, 4).
Step 3: Attach the four castors (27) to the trolleys (26)
with the screws (15), spring washers (16) and
nuts (17). Fill the bearing housings with grease
over the grease nipple.
Step 4: Attach the vertical beams (23) to the chassis be-
ams. Mount the screws (14) from above and se-
cure with the washers (2), spring washers (3)
and nuts (4).
Step 5: Attach the cross braces (22) to the chassis
beam and the vertical beam using screws (5),
washers (6), spring washers (7) and nuts (8).
Proceed with the other chassis carrier and verti-
cal carrier as well.
Step 6: Slide the vertical support (21) into the vertical
support (23) and insert one of the pins into the
holes of the vertical supports to connect and fix.
Release the other pen. Attach the height adjust-
ment lever (24) to the receptacle on the outside
of the vertical support (23) and secure it by in-
serting the bolt (10) from the inside of the lever
and the washer (14), the spring washer (15) and
the nut (11). Proceed also on the other vertical
support.
Step 7: Attach the Carrier Hook (25) to the Height Adju-
stment Lever (24) with the 13mm Bolts and Nuts.
Step 8: Insert the clamp levers (9) into the vertical sup-
ports.
Step 9: Tighten all nuts and bolts until the gantry crane
is stable.
Use protective gloves!
Use protective boots!
Wear protective clothes!
CAUTION!
Risk of crushing!
Injuries to hands and fingers may result from impro-
per use of the Mobile gantry crane.
DANGER!
For safety reasons, some installation steps must be
carried out by 2 or more persons!
Before the assembly of all parts is not completed,
the connecting screws must not be tightened yet.
It is recommended that the parts be laid, aligned
and mounted on the ground before they are tighte-
ned and the gantry crane is erected.