User’s Manual
33
3-4. Integrated Peripherals
The IDE hard drive controllers support up to two separate hard drives. These drives
have a master/slave relationship that is determined by the cabling configuration
used to attach them to the controller. Your system supports two IDE controllers--a
primary and a secondary--so you can install up to four separate hard disks.
Integrated Peripherals
Item
Available Options:
＞
OnChip IDE Device
Press Enter
＞
Onboard Device
Press Enter
＞
SuperIO Device
Press Enter
Onboard Lan Boot ROM
Disabled
Onboard Serial Port 3
3E8
Serial Port 3 Use IRQ
IRQ5
Onboard Serial Port 4
2E8
Serial Port 4 Use IRQ
IRQ10
OnChip IDE Device
Item
Available Options:
IDE HDD Block Mode
Enabled
IDE DMA transfer access
Enabled
On-Chip Primary PCI IDE
Enabled
IDE Primary Master PIO
Auto
IDE Primary Slave PIO
Auto
IDE Primary Master UDMA
Auto
IDE Primary Slave UDMA
Auto
On-Chip Secondary PCI IDE
Enabled
IDE Secondary Master PIO
Auto
IDE Secondary Slave PIO
Auto
IDE Secondary Master UDMA
Auto
IDE Secondary Slave UDMA
Auto
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA
Auto
SATA PORT Speed Settings
Disabled
PATA IDE Mode
Secondary
SATA Port
P0,P2 is Primary
34
The ENDAT-9401F/H System Board
Onboard Device
Item
Available Options:
USB Controller
Enabled
USB 2.0 Controller
Enabled
USB Keyboard Support
Enabled
AC97 Audio Select
Enabled
SuperIO Device
Item
Available Options:
POWER ON Function
Button ONLY
KB Power ON Password
Enter
Hot Key Power ON
Ctrl-F1
Onboard Serial Port 1
3F8/IRQ4
Onboard Serial Port 2
2F8/IRQ3
UART Mode Select
Normal
RxD, TxD Acitve
Hi,Lo
IR Transmission Delay
Enabled
UR2 Duplex Mode
Half
Use IR Pins
IR-Rx2Tx2
Onboard Parallel Port
378/IRQ7
Parallel Port Mode
ECP+EPP
EPP Mode Select
EPP1.7
ECP Mode Use DMA
3
PWRON After PWR-Fail
Off
․
Onboard LAN Boot ROM
The default setting is enabled or disabled LAN boot up function.
․
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sectors
read/write.
․
IDE Primary Master/Slave PIO and IDE Secondary
Master/Slave PIO
The four IDE PIO (programmed Input/Output) fields let you set a PIO mode (0-4)
for each IDE device that the internal PCI IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the
system automatically determines the best mode for each device.
