UniCarriers FRSB14-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 71 / 136

INSTRUMENTS AND CONTROLS INSTRUMENTS AND CONTROLS
2-27 2-27
• •
Do not Do not use the laser use the laser unit in a unit in a place where it place where it will will
be subject to water splashes or condensation be subject to water splashes or condensation
will occur. will occur.
• •
Do not use t Do not use t he laser unit in a place wh he laser unit in a place wh ere the ere the
laser beam might cause equipment around it to laser beam might cause equipment around it to
malfunction. malfunction.
• •
The fork The fork positio positio ning laser unit ning laser unit is intended is intended
to improve work efficiency, especially when to improve work efficiency, especially when
retrieving loads from an elevated position. The retrieving loads from an elevated position. The
operator is required to check the fork position operator is required to check the fork position
by direct observation as well as by looking at by direct observation as well as by looking at
the instrument panel. the instrument panel.
• •
The fork positioning laser u The fork positioning laser u nit should only be nit should only be
used while the truck is on a flat surface. The used while the truck is on a flat surface. The
fork position cannot be correctly monitored on fork position cannot be correctly monitored on
an inclined surface. an inclined surface.
INST INST ALLING THE FORK POSITIONING ALLING THE FORK POSITIONING LASER UNIT LASER UNIT
• •
Install the laser unit [2] so that the laser beam source Install the laser unit [2] so that the laser beam source
is 30 mm above the surface of the forks [3]. is 30 mm above the surface of the forks [3].
• •
Adjust Adjust the the limit limit switch switch [1] [1] so so that that the the laser laser beam beam is is
only emitted when the forks are level. only emitted when the forks are level.
CAUTION CAUTION
The installation and adjustment of the laser unit The installation and adjustment of the laser unit
requires a high level of skill. Leave it to your local requires a high level of skill. Leave it to your local
UniCarriers dealer. UniCarriers dealer.
20 – 42° 20 – 42°
A A
1 1
Laser beam width Laser beam width
Max. A:B Max. A:B
≒ ≒
1:0.8 1:0.8
Min. A:B Min. A:B
≒ ≒
1:0.35 1:0.35
C C = = The beam is less than 2 m The beam is less than 2 m m wide at a distance m wide at a distance
of 5 m or less of 5 m or less
A: Distance A: Distance B: Beam length B: Beam length C: Beam width C: Beam width
30 mm 30 mm
2 2
3 3
1. 1. Limit Limit switch switch
2. 2. Laser Laser marker marker
3. Fork 3. Fork
(Detail of area “A”) (Detail of area “A”)
https://www.forkliftpdfmanuals.com/