Ulvac GN-15i, Инструкция по эксплуатации

Страница: 16 / 32

10 ULVAC CRYOGENICS INCORPORATED
5. Specifications
5.1 Nitrogen generator specifications
Items Specifications
Model GN-15i
N2 production rate (*1) 15 NL/min
Discharge pressure 0.2 MPa
Purity 99 vol% (N2 + Ar)
Dew point Below -60
°C
Flow meter (*2) 25.0 NL/min
Ambient
temperature(*3)
5 - 40 °C
Ambient humidity(*3) Relative humidity 10 - 80%
Electrical rating
Voltage and frequency
Main power source 100VAC single-phase, 50/60Hz
Power consumption 800W
Operating method Input operation signals
Input and output
electrical signals
Input
Remote signal: CLOSE while in operation
Contact capacity:DC30V 20mA required
Output
Running signal: In operation (ON)
N2 supply signal: While supplying (ON)
Alarm signal: While in alarm state (ON)
Relay contact output: Continuous load current 100VAC
below 1A
Drained water
processing
Evaporation inside the equipment
Nitrogen gas exit
φ
6 quick-connect coupling
Dimensions 480(W) x 620(D) x 950(H) (excluding casters)
Weight Approx. 90Kg
Color DIC 546 1/2
Compressor 2688CS32-273 (made by Thomas) x 2
Noise level 56dB(A)
When measured from front 1m and height 1m
*1 This is the volume measured at the ambient conditions of temperature 20°C and
humidity 60% RH and converted to 0°C and atmospheric pressure. The production
volume above is the maximum under the conditions with temperature of 20°C, humidity
of 60% RH and filters are cleared. The production rate may go down depending on the
conditions such as temperature or humidity.
*2 Flow meter is made to fit the above discharge pressure. If it is used at the pressure
other than the above, conversion is needed.
*3 This is not to guarantee the performance under these conditions.