7
www.ultratecfx.com
Manual Mode Operation
MANUAL MODE OVERRIDES HAND HELD REMOTE AND DMX.
1. Set DMX thumbwheels to 600 address range before powering up the machine.
2. Turn power switch to ON position.
NOTE: Red VALID DMX LED
will start to blink continuously after powering up machine.
3. The
Ones column
needs to be set between 4 – 9 to turn ON bubble wheel motor
when fan(s) turn ON.
NOTE: When set below 4, bubble wheel motor will not turn ON when fans turn ON.
4.
The
Tens column
changes fan speed when set from 1 – 8
(9 is same speed as 8)
PUSH
PUSH
0
0
0
Valid DMX
R
emote
DMX In
DMX Out
Ad
dr
ess
Shut Down Procedure
1. Disconnect the Bubble Master from the power source.
2. Remove the bubble extension sleeve if used.
3. Using a funnel, empty the contents of the fluid reservoir back into the 1 gallon fluid container. This can be
done by tipping the unit, and pouring the fluid out of the bubble outlet.
4. Replace cap on the fluid container to keep dirt and debris from entering.
5. Rinse out fluid reservoir and bubble wheels with hot tap water tap water to remove excess bubble fluid
residue. Using a paper towel wipe out extension sleeve and bubble outlet.
6. Empty into sink or appropriate drain.
