Bubble Master DMX Operation
(This includes 110V / 220V Regular and Junior DMX Bubble
Machines)
Remote Operation
The Bubble Master DMX use standard 5 pin fog machine remote
CXP-41395PIN.
Plug the 5 pin remote cable into the 5 pin remote receptacle marked
“Remote”.
Smoke OFF/ON Switch
= Disables / Enables operation of fans and of
bubble wheel motor.
Switch must be in ON position to allow control of machine.
Flow Dial
= Allows speed adjustment of fans.
Fully CCW (Min) fans are off.
Fans start turning (slow) at about the first hash mark on remote label.
Duration Dial
= Allows bubble wheel motor to turn OFF / ON only (No
speed control).
Lowest turn ON point is 50% (1/2 way on hash mark on remote label).
Suggest this dial be left at full CW (Max) setting. This will allow the
bubble wheel motor to turn OFF / ON as soon as fans are
turned OFF / ON.
Interval Dial
= Not used for operation (Does nothing when adjusted).
1. Turn power switch to ON position.
2.The red LED on the hand held remote OFF/ON switch, will be on
solid.
NOTE:
The red valid DMX LED located between the Remote IN
and DMX IN XLR must be off.
3. Adjust the Duration dial above 50% to to enable the bubble wheel motor rotation.
4. Flip the OFF/ON switch on the hand held remote to the ON position to initiate bubble
production.
5. Adjust the Flow dial to change the fan speed.
By varying the fan speed you can control the bubble volume and height.
DURATION
INTERVAL
FOG
VARIFLOW
Smoke OFF/ON Switch
Flow Dial
Duration Dial
Interval Dial
5 pin fog machine remote
5
www.ultratecfx.com
