DMX Operation
Unit uses 2 channels for DMX control.
DMX OVERRIDES HAND HELD REMOTE
Base DMX Address
= Allows speed adjustment of fans.
0% - 8% = Fans OFF
9% - 100% = Fans ON (low – high)
Base DMX A 1
= Bubble wheel motor control OFF / ON only (No speed control)
TECH TIP:
leaving this DMX+1 value at 100% will enable the bubble wheel motor to turn
OFF / ON as soon as fans are turned OFF / ON]
0% - 49% = Bubble wheel motor OFF
50% - 100% = Bubble wheel motor ON
1. Set desired DMX address on thumb-wheels between 001 to 511.
2. Connect a 5 pin DMX cable to the DMX IN XLR.
3. Turn power switch to ON position.
4. If valid DMX signal is present, the red valid DMX LED will be on solid.
5. Adjust base DMX address to control fan speed.
By varying the fan speed you can control the bubble volume and height.
6. Adjust the next consecutive DMX (D+1) address above 50% to turn on the bubble wheels
motor.
6
www.ultratecfx.com
PUSH
PUSH
0
0
0
Valid DMX
R
emote
DMX In
DMX Out
Ad
dr
ess
