Ultrasonix SONIX Series, Руководство по обслуживанию

Страница: 127 / 136

CHAPTER 14: TROUBLESHOOTING
14.1 SYSTEM NOT POWERING UP
To check power to system:
1. Ensure AC Main (Power Plug) is plugged in.
2. Ensure Voltage Selector/EMI Filter is adjusted to regional setting. Eg. North America =
110 – 125V, China = 220 – 240V, etc.
3. Ensure the EMI Filter is in the ON state.
4. Finally, contact Ultrasonix for further instructions to power up system.
To check the fuse:
1. Ensure the system is completely turned off.
2. Use a screw driver to open the fuse box lid.
3. Use a screw driver to take out the fuse box.
4. Replace the 2 fuses on both sides of the fuse box.
Note: Ensure the fuse type is: 3AG Slo-Blo, 7A/250V
14.2 NO PRIMARY HARD DRIVE DETECTED
Check the cables of the SONIX System by removing the Ultrasound Modulo from the system and
open the Front Block door. See section
8.4 Ultrasound Modulo Servicing to remove the
Ultrasound Modulo and to open the Front Block door to access the hard drive.
14.3 SONIX MACHINE SEEMS SLOW
DICOM may be turned on even though it is not configured.
Print Keys
,
DICOM Settings
and the
DICOM Queue
will all need to be checked to ensure that DICOM is not enabled.
14.3.1 Check the Print Keys
1. Press the console MENU button.
2. Select Admin… -> Print Keys .
3. Check Print 1 , 2 and 3 to ensure DICOM is not selected.
4. Check
OK
.
SONIX Service Manual SSM – 001, Revision F Chapter 14: Troubleshooting
119