Ultrasonix SONIX Series, Руководство по обслуживанию

Страница: 75 / 136

5. Use the 10mm wrench to remove the four (4) bolts from underneath the Console.
6. Carefully pull the Console up off the mounting plate, while feeding the cable up.
8.3.2 Installing the Console
Tools required: #2 Philips screw driver
10mm wrench
2.5mm Allen key
Non-permanent Glue Stick
1. Feed the cable through the opening at the top of the assembly.
2. Plug the cables into the module through the access panel.
3. Plug in the system.
4. Start the system by pressing the console POWER button.
5. Ensure the system boots up.
6. Plug in a transducer.
7. Press the console PROBE button and select the relevant transducer from the touch
screen.
8. Ensure that the system responds to the button commands and lights up correctly.
Note: Lights are on only when there are features that are active.
9. Once the system is working, shut it down by pressing the console POWER button.
10. Once system is off, unplug from back of modulo.
11. Secure the console with the four (4), 10mm hex bolts.
12. Hand-tighten the nuts.
13. Tighten the nut a half turn as you may torque the nut.
14. Place the cable along the right side of the console, which will be covered by the plastic.
Note: There is no retaining clip, except for the plastic cover.
15. Replace the plastic cover and secure with four (4), Philips screws (top) and two (2),
Allen bolts (side).
16. Place a small amount of glue on each of the four (4) Philips screw covers and secure
them to the tops of the screws.
SONIX Service Manual SSM – 001, Revision F Chapter 8: Field Service Components
67