ENGLISH
1-17
DEUTSCH
35-51
FRANÇAIS
18-34
7. Connect your cables according to your need
The cable terminal
⑨
is available for all your required wired connections.
Please be careful during the process and gently screw the wires to the terminal block. There is no need to
force the screws, simply tighten enough for cables not to become loose.
✦
Power supply (12-24VDC +/-)
The caller station can run on batteries only. The observed battery life is 12 to 18 months.
Additionally or alternatively, you can connect a 12-24VDC power supply. This power can be provided via any source
(optional adaptor, gate power, solar panel, …) as long as it is Direct Current (DC) and 12 or 24V.
If you use both batteries and DC power supply, the batteries will then act as backup battery (in case of power failure).
If connected to DC power, your caller station will benefit from two extra features:
✦
Night lighting: When it gets dark, the caller station call button
①
will light up to welcome your visitors (and the
keypad buttons
②
, on concerned models only)
✦
Wireless gate release always available: On DC, the wireless gate release is always available, even when you are
not in communication, by a long press on the
⑬
(on batteries, unlock is only available during communication)
On battery, these features will automatically be turned o
ff
to save battery life.
DANGER: Under no circumstances should AC mains Voltage (220V) be directly connected to the terminal
blocks
⑨
.
✦
Optional external aerial
If necessary, an optional external aerial can be added to your installation. This aerial improves the wireless range by
avoiding the main obstacles in your environment: mounting wall, metal gate, wireless interference, trees, buildings, …
By using an external aerial, your wireless signal will be sent from a better starting point. Simply screw the add on
aerial to the loose cable
⑩
(remove the red tip) at the back of the caller station. For your caller station to use the
external aerial, please set the
⑥
switch to
EXT
.
IMPORTANT: If you are not using the optional external aerial, the switch must be on
INT
(the system will use
the built in aerial). The connector cable
⑩
will not be in use and can be left loose at the back of the caller
station (with the red tip).
12
