Fold & Go Model 760 PowerChair Owner’s Manual
EMC Part: 19272200 • Rev. 01 • 01/05/04
12
Battery Pack Installation
The Battery Pack is mounted directly into the frame, at the
rear and secured by a spring-loaded latch. When in
position, electrical contact is made automatically, no
connections are required. The latch keeps the Pack in
place and properly connected when driving. The velcro
straps help prevent accidental damage to the Battery Pack.
Battery installation is shown in Figure 4.
To install the Battery Pack:
• Use handle to lift Battery Pack into position
• Tip Pack towards front of vehicle so that post
engages latch
• Secure with velcro straps
Battery may not be fully charged upon installation. Refer
to the following to recharge the Battery Pack of your Fold
& Go.
Figure 4 — Installing the Battery Pack