AutoGo 550 Vehicle Owner’s Manual
EMC Part: 19285600 • Rev. 03 • 09/15/04
40
Due to environmental conditions, movement may become stiff and difficult. If
movement becomes difficult, use of a spray lubricant can be used to restore easy
movement. Use a spray lubricant such as WD-40. Use lubricant sparingly and avoid
contact with vinyl or painted surfaces.
Tires
Front and rear tires of the AutoGo 550 are foam-filled and do not require air
pressure. Tires should, however be checked periodically for damage, cuts, flat-
spots, or excessive tread wear. Damaged tires should be replaced.
Electrical Connections
Check wiring connector at the drivetrain to make sure that a tight connection is
made. If Battery Pack terminals (both terminals within tiller and recharger plug
terminals) are corroded, disconnect Battery Pack and clean all connections with a
soft wire brush. Re-connect leads and apply a protective coating (e.g., petroleum
jelly, etc.) to prevent corrosion.
Hardware Inspection
Check and make sure all fasteners are present and secure.
Cleaning Instructions
Wash your AutoGo 550 with a sponge using household detergent diluted in warm
water to clean all components. Wipe excess soapy water from the vehicle using a
clean damp cloth. Avoid getting any water on the electrical components (i.e.,
connectors, switches, Battery Pack terminals, etc.).
19285600 Rev.03.OM
9/15/04, 5:38 PM
40
