2-10
2.5.3
Receiver Address.
Each pan and tilt unit must have a unique address for control purposes. The
address is set on the board the pan and tilt is connected to. The address of
the pan and tilt connected to the mother board is set using DIP Switch S1 on
the mother board. The pan and tilt connected to the expansion board in
Models CRX-502 and CRX-520 Receivers is set using DIP Switch S1 on the
expansion board. All eight positions define the address. The switch can be
set for addresses 1 through 256.
Addresses 1 through 250 can be used
by the customer.
Addresses 251 to 256 are not available for customer use;
they are for special purposes used by the factory.
The address is called the camera number and is used by the operator to
control the pan and tilt unit, the lens on the pan and tilt unit, and the auxiliary
contacts in the receivers.
NOTE
To control the auxiliary contacts in the
receivers, the control receiver must be
addressed 2 or higher.
Содержание CRX-501
