INSTALL GUIDE
PAGE 10
Wiring Descriptions
LOCK/ UNLOCK CONNECTOR (3pin red)
Pin Function
Description
1-GREEN
Lock(-)
- Programmable LOCK output. (Menu 1)
2-RED
12volts
- 250ma 12volt output.
3-BLUE
Unlock(-)
-Programmable UNLOCK output
ANTENNA CONNECTOR (4pin Blue)
RF Antenna with Program Button and LEDs
AUXILIARY BYPASS CONNECTOR (3pin white)
Pin Function
Description
1-WHITE/ Ground While Running(-)
-
250ma ground output while
VIOLET
remote starter is active.
2-BLACK Ground(-)
-
250ma ground output.
3-RED 1)
-
250ma 12volt output.
CLUTCH BYPASS
Type 1 - Starter Wire Bypass -
The starter wire travels form the key switch
through the clutch switch to the starter motor. Connect the remote starters
Starter Output wire directly to the starter motor side of the clutch switch.
Type 2 - Negative (High Current) -
This switch grounds the factory starter relay
and allows the vehicle to start. Connect a relay to ground the output side
of the clutch switch wire when the remote starter is activated. The starter
wire is connected at the ignition switch.
Type 3 - Connect Switch -
Install a relay to connect the two wires at the switch
when the remote starter is activated. The starter wire is connected at the
ignition switch.
Type 4 - Disconnect Switch
Install a relay to disconnect one of the wires at
the clutch switch. The starter wire is connected at the ignition switch.
Testing for the correct wire is critical! Never connect to a circuit if you are not sure
of it’s operation. Contact your dealer or technical support for more information.
