Ultra Reef Borei UKB-120, Инструкция по эксплуатации

Страница: 16 / 27

ULTRA REEF
www.ultrareef.it
9
SETTING
Skimmers are often subject to malfunctions due to the
conditions of the water of the water they process.
These phenomena are normal and usually does not
pose a risk to the tanks.
Warning: To solve any malfunctions, contact the
retailer or the distributors where you have purchase
the product.
If the amount of liquid collected in the collection cup is
too dense or insufficient, increase the level (close the
flow valve) to accelerate the skimming. This is
commonly referred to as "wet skimming".
Conversely, if the collection cup fill too quickly and the
accumulated fluid is too light, decreased the level (open
the flow valve) to reduce the skimming. This is
commonly referred to as "dry skimming".
It is advisable to empty the glass as soon as the liquid
level reaches 2-3cm harvest, which should occur at
least weekly.
Warning: Finding the right point of skimming is difficult
and requires some experience. For the first time it is
normal to have difficulty in regulating the flow valve.
Warning: Do not connect pipes, filters or other systems
to the air suction line. Any modification could
compromise the operation of the skimmer
PUMPS WITH CONTROLLER
Adjusting of the pump allows you to change the
performance of the skimmer by simultaneously adjust
the amount of aspirated air and treated water.
Reducing the pump speed decreases the extraction
capacity and the consumption of the skimmer. This
solution is useful for feeding or tanks maturation time.
Conversely, increasing the speed of the pump increases
the extraction capacity and the consumption of the
skimmer.
After each variation of speed, it is necessary to wait for
the foam to stabilize. Change the speed of one step
(one LED) every 2 hours.
To adjust the water flow use the + and - keys. The blue
LEDs go on to indicate the flow quantity, from minimum
to maximum.
Legend for the LED colours on the controller
A. Blue LED on: flow power.
B. 5 min orange LED on: FEED MODE on, the pump is in
stand-by for 5 minutes.
C. Flashing blue LEDs: The pump will pause for 80
seconds after a power shutoff.
Warning: In case of abnormal noise and /or reduced
performance caused by sudden changes in electricity
supply, it is sufficient to restart the pump.