Ultimaker EXTRUSION UPGRADE, Руководство по установке

Страница: 14 / 27

14
DISASSEMBLING
1. Slide a print head axis (dis)assemble tool on either side of the left sliding block until it clicks into the axle. Fig. 26.
2. Pop up the print head shaft until it comes out of the sliding block at this side. Fig. 27.
3. Do the same on the right side.
4. Repeat the steps 2 and 3 on the front and back, using the print head axis (dis)assemble tools upside down. Fig. 28
and 29.
5. Turn all sliding blocks away from the print head. Fig. 30.
Turn the sliding blocks away from the top and always act gently.
6. Move the print head so the shafts move out of the sliding blocks and lift upwards. Set the print head aside, you do
not need anymore. Fig. 31.
26
28
30
27
29
31
PRINT HEAD