Ultimaker EXTRUSION UPGRADE, Руководство по установке

Страница: 17 / 27

17
ASSEMBLING
1. Place the Ultimaker on its right side.
2. Feed the braided sleeve through the hole at the back and the hole at the bottom. Fig. 40.
Ensure that the whole braided sleeve is through the hole, as it was before you took it out.
3. Connect the blue-orange wire to the hot end fan connector on the middle of the board. Fig. 41.
4. Connect the PT100 sensor to TEMP1 on the main board. Fig. 42.
5. Connect the yellow-green wire to the Fan PWM. Fig. 43.
6. Connect the feeder motor to E1. Fig. 44.
7. Guide the motor wires of the Y motor and feeder motor through the ferrite core and close the ferrite core. Fig. 45.
THE ELECTRONICS
40
42
44
41
43
45