MicroLED Illuminator Range
8
At any time the cycle can be stopped on a color and started again using the Lower push
button
To disable manual operation and revert to remote controller operation, recycle the power to
the Illuminator. The Remote Controller may need to be matched to the Illuminator as
detailed on page 5.
DMX OPERATION
The MicroLED4000M is programmed as a
Master
unit (See Mode designation label on rear of
unit) and is capable of interlinking to a MicroLED
Slave
Illuminator using a RJ45 cable. In this
Master /Slave configuration the Slave Illuminator will follow the Master Illuminator, but no
control from a remote DMX controller is possible. Remote DMX control can only be achieved
using MicroLEDSLAVE Illuminators. See MicroLEDSLAVE User Guide for DMX wiring
connections
Cycle
SPEED A - Fastest
SPEED B - Slower
SPEED C - Slowest
1 (White Start)
Push Once
Push Once
Push Once
2 (Red Start)
Push Once
Push Once
Push Once
The Illuminator is controlled using the 2 push buttons on the rear of the unit.
The Lower button STOPS and STARTS the color Cycle
The Upper button is used to select the Cycle speed as follows. Push the Lower button
repeatedly until the color White is displayed. The illuminator is now in Cycle 1 speed A as
detailed below. Each push reduces the speed. On the third push the color Red will be
displayed. The illuminator is now in Cycle 2 speed A
