Mic100PT V2 Light Source
4
CONNECTION
There are 2 connections required - the fibre port and the mains supply. The fibre
port should be connected first. Connect and secure the fibre optic connector into
the front of the unit, and secure using the M5 locking screw.
Plug the mains plug into the electrical supply socket. Switch on the power, the LED
indicator will illuminate, and the light source and the twinkle wheel will start up
automatically. If no light is produced consult the troubleshooting section.
NOTE: THESE LIGHT SOURCES ARE NOT MAINS DIMMABLE
.
MOUNTING
If using the metal mounting plate proceed as follows:
STEP 1
Remove the rubber feet from the bottom of the Light Source
STEP 2
Push fit three of the expansion fittings into the holes vacated by the feet as shown –
DO NOT fit an expansion fitting into the foot hole at the rear below the push buttons
STEP 3
Place the mounting plate on the base as shown and push the remaining expansion
fitting through the plate into the hole that does not have one fitted. Fit all four
screws and tighten. Do not over tighten
The luminaire can now be fixed securely to the mounting surface.
