UFESA BE0906, Инструкция по эксплуатации

Страница: 5 / 16

Advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This product complies with EU Directive
2002/96/EC. The crossed wheelie bin
symbol shown on the appliance indicates that
when it comes to dispose of the product it
must not be included in with household refuse. It must
be taken to a special refuse collection point for electric
and electronic appliances or returned to the distributor
when purchasing a similar appliance. Under current
refuse disposal regulations, users who fail to take
discarded appliances to special refuse collection points
may be penalised. Correct disposal of discarded
appliances means that they can be recycled and
processed ecologically, helping the environment and
allowing materials used in the product to be reused. For
more information on available waste disposal schemes
contact your local refuse service or the shop where the
product was purchased. Manufacturers and importers
are responsible for ecological recycling, processing and
disposal of products, whether directly or via a public
system.
Your local town council can provide you with information
about how to dispose of obsolete appliances.
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the
product any time in order to adjust it to law regulations, norms,
directives, or due to construction, trade, aesthetic or other
reasons, without notifying in advance.
Handling and operation
Before you use remove the isolation from
the battery. Please take note to the
polarity. If the scale does not operate after
you remove the insulation strip, take off the
battery and re-install it.
1 Insert one CR2032 battery into the scale.
2
Using the switch, select the appropriate
measurement unit (kg/lb/st) and place the scale on
a horizontal, stable surface.
3
Press the scale with your foot.
4
The value will appear on the display.
5
Wait until this value disappears and the value
appears on the display.
6
Stand on the scale and wait until the result is
stabilized (two flashes).
7
The scale will automatically switch off after stepping
off or after 10 seconds of inactivity.
If a value other than appears on the
display after switching on the scale, wait
for about 10 seconds until the scale
automatically switches off and then switch it on
again.
If the display does not switch on or
shows the symbol
after pressing the
scale with the foot, the battery is low and
needs to be replaced.
If the symbol appears on the
display during measurement, it means
that the scale is overloaded.