Requirements for use
Warning!
The mains electricity supply connection
cable must only be replaced by
authorised members of the
manufacturer’s Official Technical
Service.
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before turning
it back on again. This period of time is
required in order to ensure correct
appliance operation.
Avoid direct contact with the air
expelled through the expulsion tube.
Transportation requirements
The appliance is fitted with wheels to
make it easier to move around. If
necessary, you can tilt the appliance in
order to move it. You should not turn the
appliance back on again for a minimum
period of one hour after performing this
procedure.
•
Before tilting it, empty the condensed
water from the internal tank by extracting
the water drainage pipe from its housing
and removing the plug,
Fig. 7
, Do not
forget to replace the plug and reinser t
the pipe in its housing when the tank is
empty.
41
Instructions for Use
Fig. 7
Preparing the appliance
Fitting the air expulsion tube and
accessories onto the appliance.
Fit the air expulsion tube onto the fixture
with the “push” tab and thread it anti-
clockwise,
Fig. 8.
Housing for the air
expulsion assembly
Fig. 8
If easier, the housing can also be removed
from the appliance by pressing the “Push”
tab and sliding it out,
Fig. 9.
Fig. 9
Once out, thread the expulsion tube as
shown on
Fig. 10
, making sure that it is
properly secured.
