13
- It must be protected with a 10 A slow-action fuse to the model AA4010 - AA4030 and 16 A to the model AA8010 (See
characteristics table at the end).
- Should it be necessary to use an extension lead, this will have to a minimum wire gauge of 1.5 mm
2
per terminal, be fitted
with an earth wire and be no longer than 25 m.
- There is a compartment at the rear of the appliance used for storing the mains cable.
- Do not let water get inside the appliance.
- Do not cover the air intakes or outlets on your appliance.
- If the mains cable becomes damaged it will have to be replaced. To do this, get in touch with the manufacturer, after-sales
service dept. or someone similarly qualified.
Attention!
This apppliance is not suitable for dehumidification at ambient temperatures of below 18°C.
This apppliance is not suitable for dehumidification at ambient temperatures of below 18°C.
This apppliance is not suitable for dehumidification at ambient temperatures of below 18°C.
This apppliance is not suitable for dehumidification at ambient temperatures of below 18°C.
This apppliance is not suitable for dehumidification at ambient temperatures of below 18°C.
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount
After turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount
of time in order to reset.
of time in order to reset.
of time in order to reset.
of time in order to reset.
of time in order to reset.
MOBILITY
The indoor unit is fitted with wheels which allow it to be moved about. In order to move both the indoor and outdoor unit
together, hang the outdoor unit on the corresponding support fitted to the indoor unit, as shown in figure B.
Should it be necessary to tilt the appliance when moving it, the internal water tank will have to be emptied beforehand with
the help of the drain pipe (fig A,8) placed onto the drain cock (fig A,10) at the bottom of the appliance (fig C). Once the
appliance has been put back into the upright position leave it to stand for a few minutes before switching it on.
In the event that only the outdoor units is to be moved, first remove its drain plug and tilt it forward slightly to empty out any
water that might be still inside.
Attention!
Attention!
Attention!
Attention!
Attention!
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if
knocked.
knocked.
knocked.
knocked.
knocked.
INSTALLATION
Attention!
- Make sure that the appliance is horizontally level when hung, otherwise water might drip out of the tray at the bottom.
Make sure that the appliance is horizontally level when hung, otherwise water might drip out of the tray at the bottom.
Make sure that the appliance is horizontally level when hung, otherwise water might drip out of the tray at the bottom.
Make sure that the appliance is horizontally level when hung, otherwise water might drip out of the tray at the bottom.
Make sure that the appliance is horizontally level when hung, otherwise water might drip out of the tray at the bottom.
- For safety reasons, the outdoor unit must never be left hanging from just the flexible pipe that connects it to the indoor
For safety reasons, the outdoor unit must never be left hanging from just the flexible pipe that connects it to the indoor
For safety reasons, the outdoor unit must never be left hanging from just the flexible pipe that connects it to the indoor
For safety reasons, the outdoor unit must never be left hanging from just the flexible pipe that connects it to the indoor
For safety reasons, the outdoor unit must never be left hanging from just the flexible pipe that connects it to the indoor
unit.
unit.
unit.
unit.
unit.
- The outdoor unit can be hung on the wall using the wall plugs, screws and accessory which are supplied with the
The outdoor unit can be hung on the wall using the wall plugs, screws and accessory which are supplied with the
The outdoor unit can be hung on the wall using the wall plugs, screws and accessory which are supplied with the
The outdoor unit can be hung on the wall using the wall plugs, screws and accessory which are supplied with the
The outdoor unit can be hung on the wall using the wall plugs, screws and accessory which are supplied with the
appliance. If this is done then the difference in height between the indoor and outdoor units should be no more than
appliance. If this is done then the difference in height between the indoor and outdoor units should be no more than
appliance. If this is done then the difference in height between the indoor and outdoor units should be no more than
appliance. If this is done then the difference in height between the indoor and outdoor units should be no more than
appliance. If this is done then the difference in height between the indoor and outdoor units should be no more than
1.5m. (Fig. D)
1.5m. (Fig. D)
1.5m. (Fig. D)
1.5m. (Fig. D)
1.5m. (Fig. D)
- Do not trap, twist or crush the flexible pipe that connects both units
Do not trap, twist or crush the flexible pipe that connects both units
Do not trap, twist or crush the flexible pipe that connects both units
Do not trap, twist or crush the flexible pipe that connects both units
Do not trap, twist or crush the flexible pipe that connects both units
- Do not cover the air intakes or outlets on the appliance.
Do not cover the air intakes or outlets on the appliance.
Do not cover the air intakes or outlets on the appliance.
Do not cover the air intakes or outlets on the appliance.
Do not cover the air intakes or outlets on the appliance.
A) INSTALLATION THROUGH A SLIGHTLY OPENED WINDOW / DOOR
Depending on individual circumstances, the outdoor unit can be either placed on the window ledge (Fig.. E) on the
ground outside the house (Fig. F) or hung on an outside wall (Fig. G). The said position must have a smooth, flat
surface, e.g. on a balcony or a flat roof. Use the wall mount accessory in order to hang the outdoor unit.
B) INSTALLATION THROUGH AN OPENING IN A WINDOW / DOOR FRAME
This option consists in making an opening in the door or window frame in order to use the unit with the door or window
closed. To do this, make a suitably sized hole in the frame so that the connection pipe sleeve accessory fits in snugly
(Fig. H). The lid for the sleeve can be used to shut off the hole whenever air-conditioning is not required.
AA4010/4030/8010
13/9/04, 11:57
13
Содержание AA4010
Страница 2: ...2 1 4 3 2 5 15 14 16 17 18 19 FIG A 13 6 7 8 9 10 12 12 11 AA4010 4030 8010 13 9 04 11 57 2 ...
Страница 3: ...3 FIG B FIG C FIG D FIG E FIG F FIG G FIG H FIG I FIG J FIG K AA4010 4030 8010 13 9 04 11 57 3 ...
Страница 4: ...4 FIG L FIG M FIG N FIG O FIG P FIG Q FIG R FIG S AA4010 4030 8010 13 9 04 11 57 4 ...
Страница 5: ...5 FIG T FIG U FIG V FIG X AA4010 4030 8010 13 9 04 11 57 5 ...
