DIGITAL TERRESTRIAL TERMINAL
USER MANUAL
TROUBLESHOOTING
SYMPTOM
SOLUTION
DIGITAL TERRESTRIAL TERMINAL FAULTS
Does not display any message
on the front panel or DTT has
no power.
Check the main power cable and check that it is plugged
into a power socket.
Check that you have switched the mains power switch On.
Check if DTT is in standby mode.
No Picture
Ensure that DTT is switched On (see above).
Check that RF, SCART or RCA are connected correctly to
the TV or VCR.
Check that the correct channel on the TV has been selected
and the correct Video output is selected on the DTT.
Check that the UHF channel has been set properly in the
case of RF connections being used.
Poor Picture Quality
See No Picture ( above).
Check the signal level, if it is low you may need to re-align
the antennae.
No Sound
See No Picture (above).
Check that the volume level of the TV and DTT are correct
Check that the DTT and TV are not in Mute mode.
Remote Control does not Work. Point the RCU directly at the DTT Front Panel Display.
Check the Batteries of the RCU and replace if required.
ON-SCREEN ERROR MESSAGES
No Signal/Searching for Signal Check the Antennae - replace if necessary.
Check the cable from the antennae.
Check the position of the antennae - realign if necessary.
If you encounter any other error conditions/messages please contact your
Service Provider for assistance with the problem.
29
