english
english
EN-42
EN-43
Operating the unit
Operating the unit
C
C
2. Displays
1
1
5
5
2
2
6
6
3
3
7
8
9
7
8
9
4
4
SYS = Systole (top value)
DIA = Diastole (bottom value)
PUL 1/min = Pulse
Current Time
Date
WHO categorisation (see page
48)
User 1
User 2
Battery status (see page 44)
Pulse signal display during
measurement / Display of
irregular pulse (see page 49)
Before using the device for the first time, set the date
and time so that the measurements can be saved with
the correct date and time.
Keep the SET key pressed for 3 seconds while the device
is shut off. The hour display will start blinking.
4. Set date/time
3. Initial start-up of the device
When using the device for the first time, keep the SET key pressed. You will
automatically enter the mode for setting the date and time.
If the device cannot be activated, charge the device first and repeat the
procedure (see charge battery page 44).
By pressing the MEM key, the value increases by 1. Once
the correct value has been set, confirm the settings by
pressing the SET key.
After completing the date/time settings, the display
will show „dONE“ and the device will shut off.
Now you can enter the time. By pressing the MEM key
the value will increase by 1. Confirm the settings by
pressing the SET key.
Repeat these steps for setting the day, month, and year.
10
10
