Uclear HBC 100 PLUS, Руководство пользователя

Страница: 14 / 16

13 18
General Operations
Your HBC100 PLUS helmet communicator is now all set and ready to go!
Answer Button
Up Button
Intercom Operations
Two-Party Intercom
To use the intercom for the first time, you must pair your communicator to
another HBC100 PLUS unit.
The operations described here
are applicable to all modes
of operations.
Status Indicator
Speaker/
Charging socket
Pairing process needs to be carried out only once.
Power On
• Hold the Answer button for 2 seconds to power on the
helmet communicator. The status indicator will blink blue
and a power up tone can be heard.
Down Button
Helmet 1 ( 1st device)
Hold Answer and Down Button
Helmet 2 ( 2nd device)
Hold Answer and Up Button
Power Off
• To switch off the helmet communicator, press and hold the Answer button for 5 seconds.
The status indicator will blink red 5 times followed by a long beep before fully shutting
down.
Power Save Mode (Auto Power Off)
• If the intercom feature has been in use, and all Bluetooth devices have been disconnected,
the system will auto shutdown in 2 hour. If the intercom feature has not been in use and
the HBC100 PLUS is not connected to any other devices, the system will auto shutdown in
10 minutes.
Low battery
• When the battery level is low, the status indicator light will flash red twice every 2 seconds
while emitting a warning beep every minute.
Pairing
•With both helmet communicators powered off, hold Answer and Down buttons on the first
unit until you see the red light, approximately 3 seconds, then release. Once the first unit
is blinking purple, hold down the Answer and Up buttons on the second unit until you see
the red light, then release.
•Both units will blink purple. When the first communicator’s status indicator turns blue,
press the answer button once on the second communicator to end the pairing process.
•When both unit s blink blue twice consecutively, the pairing process is successful.
•It is recommended to restart the devices after the pairing process.
Start Intercom
To enable the intercom, hold the Up button for 2 seconds.
Stop Intercom
To disable the intercom, hold the Down button for 2 seconds.