31
6. TROUBLESHOOTING
Troubles
Possible Cause
Action
The Power Cord is not
properly connected to an outlet
and the Power Inlet.
Connect the Power Cord
properly to an outlet and the
Power Inlet.
The Outlet is dead.
Make sure the outlet is alive.
1.
The Display and
LEDs do not light up
when you turn on the
Power Switch.*
An excessive electromagnetic
wave or static electricity is
affecting the machine.
Turn the power off and move
the machine away from the
possible source. Turn the
power back on after seven
seconds.
There is an error code in the
Display.
Clear the error and restart.
2.
The BC-10 does not
work when you press
the Start button.*
The "Preset" number is set to
"0" with the "Preset" mode
being on.
For a test cutting, select "10"
as the "Preset" number and try
cutting again. Refer to 6.8.
The sheets are too thick.
Try thinner sheets (under 0.01"
or 0.25mm).
The lead edge of the sheets
curls too much.
Straighten the lead edge of the
sheets.
There is some silicone oil on
the sheets.
Replace the sheets.
The friction of the paper is too
much.
Try some other paper with less
friction.
The Pick-up Roller has worn
out to lose its grip.
Replace the Pick-up Roller.
3.
The BC-10 does not
start feeding sheets
when you press the
Start button.*
The Separate Pad is worn out. Replace the Separate Pad.
4.
A sheet stops after
moving slightly.
The sensor cannot detect
because the paper is irregular
(highly transparent or too
dark).
Use proper papers.
