AeroCut nano+ OPERATION MANUAL
34
5. Cut skewing
①
Make sure that the stock is put on the feed table correctly. (
Page.11)
②
Check whether the skewings are consistent or inconsistent.
If skewings are consistent :
+ Make the skewing adjust via the skew adjustment dial. (
Page.25)
+ Set the paper guides without play.
Do not set them too tight as the sheet may not be fed well.
If skewings are inconsistent :
+ Make the blower and separation time adjustments properly.
(
Page. 23~25)
+ Make sure that the sheets are printed consistently and aligned well.
6. Paper jam often occurs.
・
Make sure that papers, paper strips or paper dusts not remain inside of the machine.
・
Check the conditions of the paper stock.(
Page.7)
