AeroCut nano+ OPERATION MANUAL
33
7 Troubleshooting
1. Papers are not fed well.
・
Turn up Upper suction (
Page. 23~25)
・
Turn up Side blow (
Page. 23~25)
・
Shorten the PAPER FEED WORK TIME. i.e. less than 1.0 (
Page. 23~25)
・
Check if the paper guides on the feed table hold sheets too tight.
・
Make sure that the paper edges are not curled or waved.
・
Make sure that the papers are not heavily electric static charged.
2. The machine feeds double-sheets.
・
Turn down Upper suction (
Page. 23~25)
・
Turn up Lower suction (
Page. 23~25)
・
Turn up Side blow (
Page. 23~25)
・
Lengthen the PAPER FEED WORK TIME. i.e. 2.0 (
Page. 23~25)
・
Make sure that the papers are not heavily electric static charged.
3. The machine doesn’t detect double-feed properly.
・
The machine detects the density of the first fed sheet and compares the density of
the next sheet to the first one. Therefore, the machine cannot detect double-feed
when it occurs with the first fed sheet.
・
Adjust the sensitivity of the double-feed detection sensor. (
Page.25)
・
The detection sensor detects double feed by checking the edge of sheets as shown
on the drawing. It is recommended not to print on the sheet edge. (
Page.25)
4. The machine detects double-feed mistakenly.
・
Adjust the sensitivity of the double-feed detection sensor. (
Page.25)
・
The detection sensor detects double feed by checking the edge of sheets as shown
on the drawing. It is recommended not to print on the sheet edge. (
Page.25)
