5.
Repeat steps 1, 2 and 4 until the cartridge magazine has been
exhausted (ten fastenings). To remove the magazine, slide the base
plate forward and pull the strip out from the top of the tool body.
While doing so, do not point the tool at anyone and keep your
hands away from the front of the tool. During firing operation,
keep hands clear of both top and bottom booster chamber
openings.
ASSEMBLY
1. Push the piston into the end of
2. Insert the guide into the
the piston sleeve.
baseplate.
ª
ª
ª
ª
4. Snap the shear clip in place.
ª
ª
3. Slide the baseplate and guide
assembly onto the piston sleeve....
5. Insert the front sleeve assembly
into the steel liner of the tool body. 6. Replace the stop and rotate
opening for the stop.
NOTE:
The sleeve groove in the piston sleeve/baseplate assembly must
be aligned with the opening for the stop.
7
8
HOW TO CHANGE THE PISTON AND SLEEVE
1.
Lift the end of the annular spring
2.
Slide out the complete
and rotate toward top of tool.
operating assembly.
Pull the stop back and outward
to remove.
3.
Pry off the shear clip with the
4.
Separate the baseplate and
point of the fastener.
guide from the piston sleeve.
If the shear clip is damaged,
it must be replaced.
5.
Pull the piston out of the piston
6.
Incline the baseplate and the
sleeve.
guide will slide out.
NOTE:
If the guide does not slide out freely, push it out of the baseplate
with a piston.
