VERA-P1 series - Data Sheet
UBX-17004377 - R04
Confidential
Electrical specification
Page 16 of 28
4.6
Radio specifications
Parameter
Operation Mode
Specification
RF Frequency Range
802.11p
5.85 – 5.925 GHz
Modulation
802.11p
OFDM
Supported Data Rates
802.11p
3, 4.5, 6, 9, 12, 18, 24, 27 Mbps
Supported Bandwidth
802.11p
10 MHz
Maximum Transmit Power
802.11p
20 dBm ± 2 dB
Minimum Transmit Power
802.11p
-10 dBm
Receiver sensitivity
802.11p
10 MHz,
no multipath,
25 °C
3 Mbps
-98 dBm typ., -95 dBm min.
4.5 Mbps
-96 dBm typ., -93 dBm min.
6 Mbps
-95 dBm typ., -92 dBm min.
9 Mbps
-93 dBm typ., -90 dBm min.
12 Mbps
-90 dBm typ., -87 dBm min.
18 Mbps
-86 dBm typ., -83 dBm min.
24 Mbps
-82 dBm typ., -79 dBm min.
27 Mbps
-80 dBm typ., -77 dBm min.
10 MHz,
NLoS (Non-line-of-sight),
25 °C
3 Mbps
-95 dBm typ., -92 dBm min.
4.5 Mbps
-92 dBm typ., -89 dBm min.
6 Mbps
-88 dBm typ., -85 dBm min.
9 Mbps
-86 dBm typ., -83 dBm min.
12 Mbps
-85 dBm typ., -82 dBm min.
18 Mbps
-82 dBm typ., -79 dBm min.
24 Mbps
na
27 Mbps
na
Receiver maximum operating input level
802.11p
-20 dBm
RSSI accuracy
802.11p
Over tempearature range
+/-2 dB
Centre frequency and symbol clock tolerance
802.11p
+/-10 ppm
Transmitter spectral flatness
802.11p
All modulation modes
< +/-2 dB
Transmitter centre frequency leakage
802.11p
< -15 dB
Transmit power control step size
802.11p
0.5 dB
Transmit power control accuracy
802.11p
Over tempearature range
+/-2 dB
Table 8: Radio specifications
Table 9 shows the Highway NLoS (Non-line-of-sight) channel parameters that are used to obtain the receiver
sensitivity values in Table 8. This channel was used in RF testing at the third ETSI Plug test (CMS3).
Each tap is faded using Pure Doppler, but the second antenna has a Doppler increased by 11 Hz, which prevents
phase synchronization of channels. The RX Power listed in Table 8 refers to the power of Tap 0.
The values presented are typical values, measured at +25 °C.
Tap#
Relative Power (dB)
Delay (ns)
Doppler Frequency (Hz)
0
0
0
0
1
-2
200
689
2
-5
433
-492
3
-7
700
886
Table 9: Highway NLoS channel parameters
The adjacent and non-adjacent channel rejection measurements are provided in Table 10 and Table 11
respectively.