BVS-ZWx User Manual
Date:02-APR-2020
Ubitech Ltd.
Version: 0.9.4
Page: 20
10
SETUP Z-WAVE NETWORK
10.1
Check Custos BVS Status:
-
Before Adding into Z-Wave Network, you have to make sure Custos BVS is in Standalone mode.
-
By default, Custos BVS does not belong to any Z-Wave Network and color indicator is keeping in Yellow Blinking.
*If not, please perform “Factory Default Reset - refer to 10.4” or “Remove from Z-Wave Network – refer to 10.3”
10.2
Add Custos BVS into Z-Wave Network:
Custos BVS supports Security 2 Command Class while a Security S2 enabled controller is needed. SmartStart or Classis
Inclusion, you can use either of these modes. It supports
-
SmartStart:
Custos BVS comes with DSK Code, end-user by scanning the QR code or entering first 5 digits during inclusion is
processing that shows in DSK Code label.
-
Classic Inclusion:
Set your Z-Wave Gateway into Inclusion mode / Add device.
i.
Start: Short press Touch Sense Button 3 times.
ii.
Processing: Yellow LED and
short beep sound keeping continue. For security inclusion support, you may need to entering
first 5 digit that show on QR Code label, please refer to the instructions of central controller.
iii.
Success: Green LED on 1 second with 2 short beep sounds.
iv.
The LED indication changes to Green LED slow blinking from Yellow LED blinking.
10.3
Remove Custos BVS from Z-Wave Network:
Set your Z-Wave Gateway into Exclusion mode / Remove device.
i.
Start: Short press Touch Sense Button 3 times.
ii.
Processing: Yellow LED and
short beep sound keeping continue.
iii.
Success: Green LED on 1 second with 2 short beep sounds.
iv.
The LED indication Changes to Yellow LED blinking.