Configure the
Wireless
Security
:
Select the AES
Key
Type
,
HEX
or
ASCII
.
For the
Key
field:
HEX Enter 16 bytes (eight, 16‐bit HEX values: 0‐9, A‐F, or a‐f). You can omit zeroes and use colons, similar to the
IPv6 format.
Note: The airFiber Configuration Interface supports
IPv6 formats excluding dotted quad and "::"
(double colon) notation.
ASCII Enter a combination of alphanumeric characters (0‐9, A‐Z, or a‐z).
Click
Change
and then click
Apply
.
In
Band
Management
is enabled by default, so each airFiber radio must have a unique
IP
Address
. (If the airFiber radios use the same
IP
Address
, then you may lose access to the airFiber radios via the DATA ports.) To change the network settings:
Click the
Network
tab.
Change the
IP
Address
,
Netmask
, and other settings to make them compatible with your network.
Click
Change
and then click
Apply
.
Repeat the instructions in the
airFiber
Configuration
section on your other airFiber radio. After you have configured the airFiber radios,
disconnect them and move them to your installation site.
