Connecting Power over Ethernet
Push the button in the
Port
Cover
and slide the
Port
Cover
down to access the RJ45 connectors.
Connect an Ethernet cable to the
DATA
port.
Connect the other end of the Ethernet cable from the
DATA
port to the Ethernet port labeled
POE
on the PoE Adapter.
Connect the
Power
Cord
to the power port on the
PoE
Adapter.
Connect the other end of the
Power
Cord
to a power source.
airFiber
Configuration
The instructions in this section explain how to access the airFiber Configuration Interface and configure the following settings:
Wireless Mode Configure one airFiber AF5U as the
Master
and the other as the
Slave
.
Duplex
The airFiber AF5U supports both half‐duplex and full
‐
duplex operation. Half‐duplex operation provides more frequency planning
options at the cost of higher latency and throughput. Full‐duplex operation provides the highest throughput and lowest latency; however,
you have fewer frequency management options.
Half Duplex (default) The
TX
and
RX
Frequencies
can be the same or different to suit local interference.
Half
Duplex
Diagram
Full Duplex The
TX
and
RX
Frequencies
should be different.
Full
Duplex
Diagram
TX
and
RX
Frequencies
The
TX
Frequency
on the Master must match the RX
Frequency
on the Slave, and vice versa.
Connect an Ethernet cable from your computer to the
MANAGEMENT
port
on the airFiber AF5U.
