7
© 2021 Ubicquia Inc. | All rights reserved. Patent pending. Public use approved. | 2058 v2 October 2021
6.7
A.
Once unit is leveled, tighten
the vertical adjustment screws to
40 in-lbs torque using the 3/16”
Hex bit driver.
B.
Then tighten the horizontal
adjustment screws to 40 in-lbs
torque using the 3/16” Hex bit
driver.
7.1
The installer will need to select
which grounding option to use
based on local regulations and
guidelines, as well as selecting the
correct grounding clamp based on
arm type, diameter, etc.
STOP!
Ensure UbiHub is
connected, grounded, and
secured firmly in place before
moving on.
7. Grounding Cable Installation
6.8
Remove tether from unit.
NOTE:
Remove all protective
packaging material from the
camera prior to installation.
6.10
Tighten the camera top screw to
15 in-lbs torque using the 3/16”
Hex bit driver.
CAUTION:
The unit must
be grounded in accordance
with the local codes or
regulations defined by the local
inspector. The surface where
the grounding clamp will be
installed must be prepared to
ensure metal to metal contact.
6.9
Place the UbiHub APAI camera
over the vertical adjustment
bolts on the mounting clamp
by toeing in the bottom and
rotating upward into place.
Ensure the camera cable is
not crimped or pinched while
installing onto the clamp.