UBERHAUS DESIGN 98495003, Руководство оператора

Страница: 7 / 20

3B
3A
P G
K1
3A. Place the seal strips (K2
、
K1
、
K3) at the base of glass panel (G, P) .
3B . Insert glass panels (G& P) into their respective tracks. Do not
fully tighten hardware as further adjustments may be required.
Note: Aluminum tracks have oval holes on their sides. These holes allow
you to adjust the glass panels (G& P) at a proper level in aluminum
tracks. By adjusting depth and or giving the glass panels a slight
angle; you will ensure precise adjustment for door alignment.
10 11
D
8mm
1
Installing glass panels
4B
4C
D
4D
4A. Assemble the support bar (B2) with coupler (C) in the muff (A) and tighten using the
allen key (6) and(7) .
4B. Place the support bar on the glass panel, make sure the support bar is level on the
wall,then position(A) on the wall and mark the line.
4C . Drill hole on the marked line
Note: it is recommended that a small diameter bit be used when first drilling tiles to avoid
cracking them. Begin with the smaller bit and gradually move to larger drill bits until the
proper sized hole is attained.
4D. Insert wall plugs (4) using a rubber mallet Proceed carefully to avoid cracking the
tiles.
4E. Take the muff (A) from the support bar (B2),then attach the muff (A) to the wall using
screws (3).
F.P
back
4G.Install the glass panel support (C)and tighten it on the panels using the Allen key (8),
make sure to install rubber bumpers to avoid the risk of breaking glass panels.
4H. Repeat the same operation for the second support bar.
4 lace the support bar (B2&C) the muff (A) and tighten using the allen key (7) .
12
13
Installing the glass panels support bars
5A
G
G
5A. Install the hinges (F) on the panel (G) by placing the washers on each side
(
2 pcs
)
of the
glass panel.
Don't forget to insert the plastic cylinders into the glass holes before screwing.
Note:
Make sure the screw side of the hinge faces the inside of the shower.
5B. Install shower door (H) to the hinges that on the glass panel using the Allen key ).
Note:
Make sure to check the door direction to have handle holes on the correct side, as indicated
on the drawing.
(8
#
4
5B
H
#
4
H
Installing the shower hinges
8mm
# 3
# 2
.
5
4E
4F
A
B2
C
# 3
# 2
.
5
# 4
4A
4G
Installing the rubber seal tracks
6A ( ) . Install the vertical shower door rubber track E1
、
E2
、
E3 on panel (H). Notice that
the longer lip of the track should face inwards and overlap the door.
6B. Install the bottom rubber track (M) on the shower door (H) and cut it to size. The
longer lip of the strip must be in the internal side of the shower.
6C
. Install both magnetic tracks (
O2
) on the shower door (H) and(
O1
) on the glass panel
(P).
K2
K3
K1 K3
B2
H
Inside
Inside
Outside
H
G
H
O2 O1
H
M
E1
P
6C
6A
6B
E2
E3