Ubee Interactive
Setting Up and Connecting the DDW3611
Ubee DDW3611 Wireless Cable Modem Gateway Subscriber User Guide • November 2012
11
2
Installing the DDW3611
This chapter describes how to set up and connect the DDW3611, connect additional
devices, and troubleshoot the installation.
Topics
See the following topics:
Setting Up and Connecting the DDW3611 on page 11
Connecting Devices to the Network on page 12
Troubleshooting the Installation on page 14
2.1
Setting Up and Connecting the DDW3611
Use the following instructions to set up and connect the DDW3611. When the device is
set up and connected, refer to
Accessing the Web Interface on page 17
to configure the
device.
Important
: Subscribers contact your service provider to enable Internet access and
wireless networking.
Typically, the service provider initially configures and connects the device. The installation
steps are provided below if you wish to confirm the setup or add devices to your network.
Refer to
Connecting Devices to the Network on page 12
.
Steps
To set up the device:
1. Remove the contents from the device packaging.
2. Place the DDW3611 in the best location to connect to other devices, such as PCs or
gaming consoles.
Place the wireless cable modem and wireless clients in open areas far away from
transformers, heavy-duty motors, microwave ovens, refrigerators, fluorescent
lights, and other manufacturing equipment. These items can impact wireless
signals. A wireless signal can become weaker after it has passed through metal,
concrete, brick, walls, or floors.
Place the device in a location that has an operating temperature of 0
˚
C to
40
˚
C (32
˚
F to 104
˚
F). Refer to
Understanding Safety and Regulatory Information
on page 1
for more safety information.
3. Power on your PC. The PC must have an Ethernet network adaptor or Ethernet port
and an Internet browser installed, such as Netscape or Internet Explorer. The following
browsers are supported:
For Windows 2000, XP, Vista, Windows 7, Firefox 1.07 and higher, Internet
Explorer v7 and above, Netscape.
For MAC OS X, 10.2, and higher: Firefox 1.07 and higher, Safari 1.x and higher.
4. Connect the power cord included in the product package to the back of the cable
