ubbink Solaris ELITE, Руководство по эксплуатации

Страница: 9 / 15

9
Operating instructions for Solaris Elite
1
Ordering replacement parts
When ordering replacement parts or in the course of trouble shooting we will
require the following information:
Troubleshooting
Some problems caused by minor faults you can fix yourself. Follow the instructions below for each respective problem. However, if it is not possible to solve the problem this way, please contact Customer Service
and provide the necessary information listed under ‘Ordering replacement Parts’.
Capacity 18 l
Maximum temperature -14 °C – 35 °C
Operating pressure Max. 3.5 bar
Height 1.18 m
Dimensions of baseplate 175 x 175 mm
Warranty
Our products are subject to strict quality controls. However, we are very sorry if the product nevertheless fails to function properly. The following applies to the assertion of warranty claims:
1. The warranty conditions are aimed exclusively at consumers, i.e. natural persons who do not intend to use this product in the course of their commercial or other self-employed activity.
2. Our warranty extends to the repair of material and manufacturing defects or the replacement of the device.
3. Warranty claims are valid for a maximum of 2 years from the date of purchase. The assertion of warranty claims after expiry of the warranty period is excluded.
4. If the item is covered under warranty, it will be repaired free of charge or replaced free of charge by an identical item or a comparable item of our choice.
Repair or replacement of the device does not result in an extension of the warranty period, nor does this service initiate a new warranty period for the device or for any installed replacement parts.
The following are excluded from our warranty:
-
Damage to the device caused by failure to observe the operating instructions, failure to observe the maintenance and safety regulations or by exposure of the device to abnormal environmental conditions
or by lack of care.
- Damage to the device caused by misuse or improper use (such as overloading the device or using non-approved use of tools or accessories), penetration of foreign bodies into the device (such as sand,
stones or dust), use of force or external influences (such as damage caused by falling down).
- Damage to the device or parts of the device resulting from normal, customary or other natural wear and tear.
2
Disposal of packaging :
Dispose of the packaging according to type. Put cardboard and card into waste paper, plastic film, metal foil and bags to recyclables collection
Non-use/ winter storage
Non-use
If you are not going to be using the shower for an extended period, switch off the water supply, turn on the mixer control (7) and tap (9) and drain the water in the shower. Then leave the mixer control (7) and tap
(9) on.
Winter storage
Before the outside temperature drops to <5 °C, switch off the water supply, turn on the mixer control (7) and tap (9) and drain the water in the shower. Then leave the mixer control (7) and tap (9) on. Disconnect
the water supply (see Water supply connection options) at the tap connection (2) and remove the screw fitting (3) to drain the water inside the shower.
Care and maintenance
Cleaning the hand shower and tap
Only use water and if necessary, a descaling agent. Do not use any aggressive chemicals. To ensure the full flow rate, clean the hand shower (5) and tap (9) periodically, or when limescale or dirt builds up. Do not use
scouring agents.
Periodically unscrew the hand shower (5) and the screw connection between the shower and the shower hose (6) to clean the sieve inserts inside them.
Cleaning the shower housing
Only use water and a soft cloth. Clean the shower housing (1) periodically, or if dust and dirt have built up, to ensure that the shower housing (1) is best able to convert solar radiation into warm water.
Problem Cause Solution
No water comes out of the hand shower
The mixer control is off Check if the mains supply is turned on
Kink in the garden hose Turn the mixer control (7) right (red) so that the water flows out of the hand shower (5)
Tap connector blocked Check whether the garden hose is kinked and remove the problem.
Hand shower blocked
Unscrew the tap connector (2) and check whether solids have built up.
The shower is in the shade
Unscrew the hand shower (5), hold a hosepipe over the inlet of the hand shower and see whether
water flows through. If not, the hand shower is probably blocked with limescale
No warm water
The water does not heat up A shady installation position may prevent the shower from heating up – position the shower in´the sun.
The mixer control is off Wait about 2 hours, until the sun has heated the water
The water is turned off Turn the mixer control (7) to the right (red)
Only hot water
The mixer control is off Check if the mains supply is turned on
Kink in the garden hose Turn the mixer control (7) so that the water flows out of the hand shower (5)
Tap connector blocked Check whether the garden hose is kinked and remove the problem.
Kraanaansluiting is verstopt Unscrew the tap connector (2) and check whether solids have built up.
Water continues to drip after the mixing control
has been turned off
This is not a fault, but a function of the system. The heating of the water causes am overpressure, which can lead to dripping/ a light flow of water for about 15
minutes. Once the pressure has dissipated, the water will stop dripping.
1. Part name
2. Article number of the device
3. Copy of the invoice
4. Description of the fault
Technical data
Manual Dusche Solaris Elite 7505510 2022.indd 9 Manual Dusche Solaris Elite 7505510 2022.indd 9 19.12.22 09:11 19.12.22 09:11