UAZ UAZ-374195, Руководство по эксплуатации

Страница: 70 / 90

70
Adjust the cable length (when replacing the cable) as follows:
1. Push brake lever 1 to its front most position.
2.
Unscrew locknuts of adjusting yoke 7, unclip and remove the stud connecting the yoke and brake drive lever.
3. Adjust the cable length by turning the adjusting yoke until the holes in the yoke and the lever are aligned, with
selecting slack in the cable. In doing so, the lever should touch the ball housing of the expansion mechanism.
4. Unscrew the adjusting yoke 1.5-2 turns, align the holes in the yoke and the lever, insert the pin, cotter pin and
tighten the locknuts.
When the parking brake is properly adjusted, the vehicle should be braked when installing the lever pawl in the 2th
- 3rd slot of the sector, counting from the rear part (2-3 clicks).
It is forbidden to check the operation of the parking brake system when starting off or moving. Check the
operation of the parking brake only aslope.
Fig. 9.34 Parking brake drive:
1 - drive lever; 2 - pull rod; 3 - bracket; 4 - cable 5 - protective pipe; 6 - bracket mounting of protective pipe; 7 - yoke cable; 8 - lever; 9
- drum parking brake; 10 - adjusting screw; 11 - switch signal lamp
ELECTRICAL EQUIPMENT
Relay and fuse box
The relay and fuse box is located on the front panel rail extension under the head instrument panel to the right of the
passenger (Fig. 9.35, 9.36). Layout diagram of the relay and fuses located on the inside of the box cover. The differential
lock relay is mounted to the left of the relay and fuse box on the head panel rack.
To access the relay and the fuses of the relay box, you must remove the cover of the box.
Fig. 9.35 Location of relay and fuse box:
1 - bracket; 2 - relay and fuse box cover; 3 - relay and fuse box; 4 - front panel rail