UAV-1004178-001 Rev A
ECCN 7A994
Page
28 | 28
9 Post Installation Checks
Connect the system as shown in the Post Installation configuration
diagram.
STEP
CHECK
Launch the PC Ping20XSControl application
Set Port to the USB or serial port connected to the
ping200XR
Set the App Baud to 57600
Set Protocol to UCP
Connect the Antenna
Apply power from a minimum of a 11V, 1A power source
Confirm that the Green LED comes on after power-up
‘Pkts:’ should start counting confirming that the app is talking
to the transponder
Confirm ‘ICAO Address’ is correctly programmed and not
000000
Confirm ‘Baro Altitude’ is correct for your field elevation
After the GPS has had time to lock, confirm that ‘Latitude’
and ‘Longitude’ are correct
Check the A, C, S and ES Mode boxes
Observe the Red LED flashing about four times a second.
This indicates 1090ES ADS-B transmissions
If you are in range of Radar, the Green LED will flash during
interrogations
Using an EFB App such as ForeFlight mobile, connect via
WiFi to pingUSB powered by a portable USB 5V power
supply.
The separation between the transponder and pingUSB
needs to be at least 500ft
The aircraft will appear as traffic on the EFB application
10 Support
For additional questions or support please visit: