8
SPECIFICATIONS:
Rotomolded Body:
Vacuum:
VAC Shutoff:
Pump:
Waterlift:
Heat:
Heater:
Wand:
Weight:
Dimensions:
Lifetime Warranty
Two 5.7”, 2-stage
Electronic float
150 psi, demand diaphram pump
86” -- 200 CFM
212º F Max
2000 Watts
Stainless steel, double bend, twin tip
100 lbs.
24W x 28L x 41H (inches)
TROUBLE SHOOTING:
IF THIS OCCURS
CHECK THIS
NO SPRAY
PUMP DOES NOT RUN
Solution tank is empty, or filter is plugged up.
Clogged spray tip.
Pump not running.
Valve on wand not operating.
Solution hose not completely connected to hose or to machine.
LOW SUCTION
NO SUCTION
LOW HEAT
NO HEAT
This pump has a built-in pressure switch, so it only runs when you release the
pressure by spraying. Make sure pressure has been released. Remove the hose
from the outlet side of the pump and hold it over a bucket. Turn on the pump to see
if water flows through the pump. If so the problem is not in the pump.
Debris is plugging cleaning tool or vacuum hose.
Drain gate is not completely closed, or seals are damaged.
Vacuum dome is not seated or is damaged.
Ball in the float is blocking air flow. Turn off the vacuum so the ball will drop down.
No power to motor. Does the switch light up? If not, the switch may be bad or there
may be no power getting to the switch. Check wiring connections.
Test the switch.
Test the vacuum motor.
Spraying too long. Try spraying for 12-15 seconds, or about three strokes.
Heat exchanger needs to be flushed.
Wrong tool being used. Too much water passing through. Longer hose or larger
diameter hose, than standard.
Heat is not turned on. Either the green light must be on or the heat switch must be
turned on.
No power in the wall outlet - check to see if the breaker has tripped.
No power to the heat switch - check wiring for ‘opens.”
No power out of heat switch, follow troubleshooting steps to isolate the problem.
Call your distributor for additional help.
SOLUS-150
