PAGE 8 OF 24
0323 IH-1030
TROUBLESHOOTING
1-800-295-5510
uline.com
PROBLEM
CAUSE
SOLUTION
Air leak from trigger
O-ring on valve or on tube is
damaged.
Replace O-ring.
Air leak from exhaust
port
O-Ring on valve or on tube is
damaged.
O-Ring on piston is damaged.
Replace O-ring.
Air leak from cylinder
Piston rod port O-ring is damaged.
Replace O-ring.
Slow & short travel
cycling
Check for loose screw or wear of
parts.
Position eccentric pin and tighten screw.
Recheck for maximum efficiency.
• Adjust pin slightly upward if due to short travel.
• Adjust pin slightly downward if due to slow
cycling.
Excessive jams
Slow & short travel cycle.
Teeth screws are loose.
Wrong staple size.
Insufficient lubrication.
Adjust as noted above.
Tighten screws.
Check staples.
Clean and lubricate.
Uneven clinch
Wrong staple size.
Check for proper leg length adjustment and
clincher size.
Unclinched staple
Teeth are loose or broken.
Slow & short travel cycle.
Check & replace teeth as needed.
Adjust as noted above.
WARNING! Stop using the stapler immediately if any of the following problems
occur. Serious personal injury could occur. Any repairs or replacements must
be done by a qualified person or authorized service center only.
