02/2005
5
www.U-LineService.com
WH95TP, BI95BTP and BCM95 Ice Makers
Reversing the Door
All units may be left- or right-hand opening.
Note:
The grille should not yet be installed. If it has been
installed, remove it for door reversing. See
Page
10
.
To reverse the door:
1. Remove travel pin from
cabinet (two screws).
See
Figure 4
. Slide
assembly through
flange and set aside
to be used later.
2. Remove top hinge from
cabinet (three screws).
See
Figure 5
. Hold door
to keep it from falling.
Slide hinge through
flange.
3. Lift the door off the
bottom hinge.
4. Remove bottom hinge from cabinet (two screws). See
Figure 6
. Remove screws on opposite side of cabinet
(
Figure 7
). Note that there may be a nut behind one or
both screws on either side.
5. Install hinge on opposite side, bottom of cabinet. See
Figure 8
. Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
6. Relocate plastic spacer/
bushing on bottom of
door to opposite side,
and place door on
bottom hinge pin. See
Figure 9
. Clean out
bushing hole in door
bottom with a
screwdriver if necessary.
7. Remove plastic travel
pin from door handle
and relocate on
opposite side. See
Figure 10
.
8. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See
Figure 10
.
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Bushing
Figure 9
Travel
Pin Hole
Travel
Pin Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
Figure 10
