PAGE 3 OF 8
0313 IH-3827
TURNING POWER ON AND OFF
Press the On/Zero button to turn power on.
The balance performs a segment check. The balance
then displays the last selected application mode.
To turn power off, press and hold the Off button until OFF
is displayed, then release the button.
OPERATION
Press and Release
Menu Function
Press and Hold
Yes
No Back Exit
BUTTON CONTROL FUNCTIONS
Four multifunction buttons are used to operate
the balance and navigate the menus. The
function of each button is shown below.
ON/ZERO
FUNCTION
TARE
Primary
Function
If balance is off,
turns balance on.
Sends current display value
to serial interface.
Operation is dependent on
the application mode.
Performs tare operation.
Secondary
Function
Off
Turns balance off.
Unit
Changes weighing unit.
Mode
Changes application
mode.
Menu-Cal
Enter the user menu.
Calibration is the first
sub-menu.
Menu
Function
Yes
Accepts the current
(blinking) setting on the
display.
No
Rejects the current (blinking)
setting on the display.
Increments a value being
entered
Back
Reverts back to previous
menu item.
Decrements a value being
entered.
Exit
Immediately exits menu
mode.
Aborts a calibration in
progress.
USING BUTTON CONTROL FUNCTIONS
SETTING THE BALANCE TO ZERO
Remove the load from the pan and press the Zero
button to set the display to zero. When the weighing
pan or platform is empty, the Center of Zero indicator
turns on when the measurement is 1/4 d of the
zero setting.
TARING
Taring refers to the action of allowing for the weight of a
container so that only the weight of objects held in the
container (net weight) is displayed.
TO TARE
Place the empty container on the pan and press the
Tare button. Add material to the container. The net
weight of the material is displayed. To clear the Tare
value, remove the container from the pan and press the
Tare button.
AUTO TARE
Auto Tare automatically compensates for container
weight so the balance displays net weight. Auto Tare
must be set ON in the Setup sub-menu. The secondary
display shows PLACE CONTAINER (blinking). When the
container is placed on the pan, it is automatically
tared and Net weight is displayed. The Tare value is
automatically cleared when the container is removed
from the pan.
PRESET TARE
Use the xT command in the command table to enter a
preset tare value through a computer. To clear the Tare
value, enter a value of 0.0.
CHANGING UNITS OF MEASURE
The Adventurer Pro can be configured to measure
in a variety of units, including custom units. The Unit
Sub-menu is used to enable or disable a specific unit.
