ODIN-W2 series - System Integration Manual
UBX-14040040 - R03
Advance Information
Qualifications and Approvals
Page 25 of 33
4.3
UL listing information
The ODIN-W2 series module is under development currently and more information will be available when
the module is fully tested and approved.
4.4
Japan Radio Equipment Compliance - Labeling Requirements for End
Product
The ODIN-W2 series modules are in Advance Information status as mentioned in Document status
explanation section. Hence, the following information is not fully valid and completed yet but will
be when the module is fully tested and approved in the Production Information stage as
mentioned in the Document status section:
When a product integrated with an ODIN-W2 module is placed on the Japanese market, either must:
•
the ODIN-W2 module be affixed with a label with the Giteki marking below.
In this case is it recommended that the product is marked with “Contains MIC ID:
R
204-510009”.
•
the product be affixed with a label with the Giteki marking below. The marking must be visible for
inspection.
204-510009
この製品は屋内においてのみ使用可能です
Figure 9: Giteki mark,
R
and the ODIN-W2 MIC certification number. The “Indoor use only” information translated into
Japanese below is mandatory if the product is operating in the 5.2/5.3 GHz band.
The recommended size of the Giteki mark is Ø5.0 mm but the minimum size is Ø3.0 mm.
The end product holder should also include a copy of the Japan Radio Certificate to the end product technical
documentation. Contact [email protected] for a copy of the Radio Certificate.
4.5
Compliance with RoHS directive
The ODIN-W2X product is produced according to the RoHS (Restriction of the use of certain Hazardous
Substances in electrical and electronic equipment) directive and complies with the directive.
