u-blox LEA-6 series, Руководство по интеграции оборудования

Страница: 36 / 62

LEA-6 / NEO-6 - Hardware Integration Manual
GPS.G6-HW-09007-A Preliminary Design-in
Page 36 of 62
GND
RF_IN
GND
V_ANT
VCC_RF
Active Antenna
ADDET_N
V_ANT
Antenna
Supply in
Analog GND
R1
R2
R3 R4 R5
T2
PNP
T1
PNP
C1
C2
FB1
AADET_N
u-blox 6 module
Figure 31: Schematic of open circuit detection variant B (for exact pin orientation see data sheet)
The open circuit supervisor circuitry shown in Figure 31 has a quiescent current of approximately 2mA.
This current can be reduced with an advanced circuitry such as shown in Figure 30.
References Value Tolerance Description Remarks
C1 2.2 µF
±
10% Capacitor, X7R, min 10 V
C2 100 nF ±
10%
Capacitor, X7R, min 10 V
FB1
600
Ω Ferrite Bead e.g. Murata BLM18HD601SN1
R1 15
Ω ±
10% Resistor, min 0.063 W
R2
10
Ω ±
10%
Resistor, min 0.250 W
R3, R4
10 k
Ω ±
10%
Resistor, min 0.063 W
R5 33 k
Ω ±
10% Resistor, min 0.063 W
T1, T2 PNP Transistor BC856B e.g. Philips Semiconductors 7
Table 8: Active antenna supervisor, bill of material
Status reporting
At startup and on every change of the antenna supervisor configuration the u-blox 6 GPS/GALILEO module will
output a NMEA
($GPTXT ) or UBX ( INF-NOTICE ) message with the internal status of the antenna supervisor
(disabled, short detection only, enabled).
None, one or several of the strings below are part of this message to inform about the status of the active
antenna supervisor circuitry (e.g. “
ANTSUPERV= AC SD OD PdoS ”).
7
Transistors from other suppliers with comparable electrical characteristics may be used.
Downloaded from DatasheetLib.com - datasheet search engine