TYROLIT Hydrostress TBS510, Руководство по эксплуатации

Страница: 22 / 33

22/33
5. OPERATION
5.1. Safety
Note The masonry band saws may only be put into operation, if all starting preparations (see 3.4) are
met. If this is not possible, the operation of the masonry band saws is prohibited.
Note The authorised operator must guide the feed movement when cutting using the saw table.
Standing is limited to this area of the masonry band saws.
The machine may only be operated by one person.
5.2. Cutting with the masonry band saw
Danger
Opening of the side doors or reaching into the rotating saw belt during cutting is prohibited.
These works may only be carried out with the saw belt at a standstill and the drive motor turned
off.
Note Observe the intended use of the masonry band saw!
•
Place the masonry stone on the saw table (Pos. 2) to the stop
• Switch on the masonry band saw via the main switch (Pos. 1) and wait until the drive
motor has reached its complete speed
• Guide the feed movement for cutting the masonry stone slowly using the handles (Pos. 3).
The masonry band saw switches off after cutting through the masonry stone
Danger Cleaning the machine while running is prohibited!
To clean, switch off the machine and wait until the saw belt no longer turns. Never clean with a
brush or a scraper in the hand if the saw belt is still running.
Caution If the saw belt tears, first switch off the machine and wait until the saw belt stops before
opening the side door.
Note After finishing work the saw belt must be released to take the tension off the bearings of the saw
belt wheels. Before starting work the saw belt must be tightened again.