5
Acceptance and transportation
EN Floor grinding machine FGE 450
9
4.5 Mounting the ETX locating plate
1.
Tilt the machine (
!
Chapter 4.2).
2.
Push the ETX locating plate [25, Fig. K] onto the
guide bolts and screw tight with the central fixing
screw M8x20 [28, Fig. K].
3.
Set the machine upright, swivel and lock the
guide handle in standard position
(
!
Chapter 3.1).
4.6 Cleaning the machine
1.
Tilt the machine (
!
Chapter 4.2).
2.
Clean the machine and tools dry with a cloth or
suitable agents.
3.
Set the machine upright, swivel and lock the
guide handle in standard position
(
!
Chapter 3.1).
4.7 Checking electrical components
Only suitably knowledgeable, qualified profes
sional electricians may perform work on any
electrical parts of the system.
Risk of fire due to faulty electrical cables!
—
Check the mains cable and power plug regularly
for functional safety.
4.8 Final tasks
Either decommission the machine
a.
Disconnect the power plug [13, Fig. B] from
the mains.
b.
If necessary, activate the lever [11, Fig. B]
and empty the tank [4, Fig. A/I].
Reduce the projection if necessary:
c.
Swivel and lock the guide handle in the
front position (over the drive motor)
(
!
Chapter 3.1).
or
—
Restart the machine
(
!
Chapter 3.1 Ć page 6).
5
Acceptance and transportation
Observe the safety instructions in Chapter 2.
5.1 Machine acceptance
The packaged machine is supplied complete from the
manufacturer.
1.
Unpack machine and check the delivery slip to
make sure all parts are delivered.
2.
Check for any transportation damage.
3.
In case of damage, contact the transport com
pany promptly.
4.
Report any problems to the manufacturer imme
diately.
Complaints at a later date cannot be acknowled
ged!
5.2 Transporting the machine
The machine may only be transported if it has
been switched off and the ETX locating plate is
at a standstill!
Do not lift any additional loads together with the
machine!
During transport, the guide handle [1, Fig. A/B]
should always be locked in position [3, Fig. A/D]
with the clamping lever!
Risk of injury from heavy loads!
During transport, the specified threshold values
for lifting and carrying must be observed!
Use devices for lashing and transporting the unit
that have been rated to handle its full weight
and dimensions. Observe weight data on packa
ging or in the accompanying documentation!
The crane hook or lashing gear may only be
attached at the specified position [
!
Fig. E]!
Wear safety shoes!
Wear safety gloves!